Chamber Heater Operation

ALWAYS DISCONNECT INPUT POWER BEFORE SERVICING THE CHAMBER HEATER SYSTEM

The chamber heater may be run at up to 160 degrees C. The chamber heater may be activated on CI Local Mode software by going to the temperature tab, entering the desired target value into the text field, and clicking the check box to set the target value. The heater and blower will power on once the value is set.

If the heater does not immediately rise and the fan does not turn on, then the thermal circuit breaker may have tripped. A thermal breaker is used to control for overtemperature events and cuts all power to the blower and the heater.

To reset the breaker, press the red button mounted to the top of the heater unit shown in the picture below.